1887 LAT OPTIONCLASS HPART # 7305601REV. ARevision: 06/20/02USER’S GUIDEWARNING:Read and follow all directionsfor each step to insure properassembly o
STEP 9:FIGURE 91031• Place one 3-1/2” PULLEY (9) into the loop of the CABLE (12) below the second and third PULLEY of the TOP BOOM (4) as shownin F
11STEP 10:FIGURE 10• Route the threaded end of the 121-3/4” CABLE (12) through the slot of the PULLEY HOUSING then SECURELY assemble one 4-1/2”P
12STEP 11:FIGURE 11• Loop the 121-3/4” CABLE (12) around one 3-1/2” PULLEY (9) as shown in FIGURE 11.• LOOSELY assemble the 3-1/2” PULLEY (9) to
13STEP 12:FIGURE 12Thank you for purchasing the Parabody 887 LAT OPTION. If unsure of proper use of equipment, call yourlocal Parabody distributor or
MAINTENANCEMODEL #________________________SERIAL #_________________________DATE OF PURCHASE: _____________DEALERS NAME: _________________DEALERS PHONE
15NOTES:LIMITED WARRANTYParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The Warranty terms apply to IN
INTERNATIONAL OFFICESLife FitnessAtlantic BVAtlantic HeadquartersBijdorpplein 25-312992 LB BarendrechtThe NetherlandsPhone: (180) 646 666Fax: (180) 6
THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OFEQUIPMENT. TO MINIMIZE RISK FOLLOW THESE RULES!1. Before using, read all the warnings and
IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the ParaBody 877 Lat Option. Please read these instructions thorou
4PARTS LISTPART #LEA6800209LEA6800610LEA6800809LEA6801009LEA6801110LEA6759810LEA6274410LEA6725310LEA3116201LEA3116101LEA6802101LEA6671601LEA6692601LEA
5FIGURE 2STEP 2:01234561/2 1/2 1/2 1/2 1/2 1/2• LOOSELY assemble the PULLEY HOUSING (3) and the UPRIGHT (1) to the LOWER CROSS SUPPORT using two 3
6STEP 3:FIGURE 3• Insert two 2-1/2” ROUND END CAPS (19) into the ends of the ADJ. FOOT SUPPORT (2) as shown in FIGURE 3.• Insert one 1-3/4” END
7STEP 4:FIGURE 401234561/2 1/2 1/2 1/2 1/2 1/2• Attach eight 1 X 1” GLIDES (15) to the ends the CARRIAGE (6) as shown in FIGURE 4 using the followi
8STEP 6:FIGURE 6• LOOSELY assemble the TOP BOOM (4) to the UPPER CROSS SUPPORT using two 3/8 X 4” BOLTS (38), four 3/8” WASHERS (30)and two 3/8” LO
901234561/2 1/2 1/2 1/2 1/2 1/2STEP 8:FIGURE 8• Route the 115-1/4” CABLE (11) through the TOP BOOM (4) as shown in FIGURE 8.• SECURELY assemble
Comments to this Manuals