Parabody 661101 User Manual

661101 LEG PRESS ADAPTER KITPart #7049801Rev. BRevision: 07/19/011ASSEMBLY INSTRUCTIONS

10 FIGURE 10STEP 10• SECURELY attach the FRONT LEG (1) to 660 BASE using two 1/2 X 3” BOLTS (15), two 1/2” WASHERS (12) and two 1/2” LOCKNUTS (13

11STEP 11 DETAIL 11 FIGURE 11SEE DETAIL 11LEGCABLELATCABLEPRESSCABLED-RING• Run the LEG PRESS CABLE through the correct hole on the d-ring and

12STEP 12• Assemble the 72” ELASTIC CORD (7) from the LEG PRESS CABLE (8) around the 2” PULLEY (5) in the TOP BOOM as shown inFIGURE 12. FIGURE 1

STEP 14 FIGURE 1413• SECURELY attach the four previously removed 3/8 X 1” BUTTON HEAD CAP SCREWS to the rear SHROUD. See FIGURE 14.Thank you for

IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the 661101 Leg Press Adapter Kit. Please read these instructions t

STEP 1 FIGURE 1PART #67477083116201310810264271013118701320150162718016747901KEY12345678QTY12111111PART #310270131025013102802310250231028013102902

STEP 2 FIGURE 24REARSHROUD• If the 663101 SECOND STACK OPTION is not installed, the rear SHROUD opening must be removed. Apply pressure to thebot

FIGURE 3STEP 3• Remove two 3/8” LOCK NUTS, two 3/8” HEX NUTS, two SWIVEL SNAP (keep elastic cords attached), two 3/8 X 1/2” SPACERS, and one 3/

6 FIGURE 4BASEHEX NUT 3/8” LOCK NUT2STEP 4• Assemble the two previously removed 3/8” HEX NUTS, two previously removed SWIVEL SNAPS, one 3-1/2” PU

FIGURE 7A(WITHOUT 663101SECOND STACKOPTION)STEP 7A 3/8” LOCK NUT TOP BOOM 9 3/8” HEX NUT• SECURELY assemble one 2” PULLEY (5) to the 3/8” TH

FIGURE 7B (WITH663101 SECONDSTACK OPTION)STEP 7B• If the 663101 SECOND STACK OPTION is NOT installed proceed to STEP 8 .TOP BOOM3/8” X 1” 1610

9STEP 9 FIGURE 9• Route LEG PRESS CABLE (8) around the 3-1/2” PULLEY on the LEG PRESS and UNDER the 3-1/2” PULLEY on the FRONT LEG (1)as shown in